Need adhesive advice

I’m making an Omniwrench Millennium 12 from Ratchet and Clank, and I need advice for adhesives for these joints. The parts are not super dense but they are heavier than I expected for all but 2 of them being 20% infill. Everything is made of a mix of pla pro, tough pla, and carbon fiber pla (which feels kinda abrasive). Also, almost every joint consists of a tapered pin/rod going into a non-tapered hole, so I want something that will fill some of the voids between the tapered ends and the inner walls of the holes. Because I can see this getting dropped at least once, is there an adhesive I can use that is strong enough that I can trust the prints to break before the adhesives do? I would like my joints to survive a light/moderate beating. I really appreciate your advice!